Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two plastic plates with a plastic opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #000 screwdriver, remove the 3mm screws. Be sure to do this for the top and bottom of the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove SIM card tray with paperclip or SIM card tray removal tool.
-
Push down on the phone beside the camera and up on the backplate with your thumbs to remove the back plate. Remove adhesive if necessary.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the plastic opening tool in the highlighted indent, and push up on the battery to remove it.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the exterior cover with a Torx 2 screwdriver, to remove two 3.0mm screws.
-
Remove the 4.0mm screw with a Phillips #000 screwdriver.
-
Using the blue plastic opening tool, remove the exterior cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Phillips #000 screwdriver to remove each of the four 1.5mm screws.
-
Use a Phillips #000 screwdriver to remove each of the three 3.0mm screws.
-
Use the plastic opening tool to remove the speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a pair of tweezers to remove the orange data cable as shown.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the plastic opening tool to lift the microphone out of place.
-
Use a pair of tweezers to lift the microphone out of the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To remove the vibrator, use the plastic opening tool to pry it out.
-