Repara tus cosas Comunidad Tienda

Blu Grand M Speaker Replacement

Introducción

If your phone is not making any noise or the sounds are distorted while on speaker phone or playing videos, the speaker may need to be replaced. You will need to follow the battery replacement guide before you can start this repair guide.

Qué necesitas

  1. Blu Grand M Speaker Replacement, Battery: paso 1, imagen 1 de 2 Blu Grand M Speaker Replacement, Battery: paso 1, imagen 2 de 2

    • Remove the two plastic plates with a plastic opening tool.

    Editar

  2. Blu Grand M Speaker Replacement: paso 2, imagen 1 de 1

    • Using a Phillips #000 screwdriver, remove the 3mm screws. Be sure to do this for the top and bottom of the phone.

    Editar

  4. Blu Grand M Speaker Replacement: paso 3, imagen 1 de 3 Blu Grand M Speaker Replacement: paso 3, imagen 2 de 3 Blu Grand M Speaker Replacement: paso 3, imagen 3 de 3

    • Remove SIM card tray with paperclip or SIM card tray removal tool.

    • Push down on the phone beside the camera and up on the backplate with your thumbs to remove the back plate. Remove adhesive if necessary.

    Editar

  5. Blu Grand M Speaker Replacement: paso 4, imagen 1 de 2 Blu Grand M Speaker Replacement: paso 4, imagen 2 de 2

    • There is a patch of adhesive underneath the battery, which can make it difficult to remove.

    • Place the plastic opening tool in the highlighted indent, and push up on the battery to remove it.

    Editar

  6. Blu Grand M Speaker Replacement, Speaker: paso 5, imagen 1 de 2 Blu Grand M Speaker Replacement, Speaker: paso 5, imagen 2 de 2

    • Remove the exterior cover with a Torx 2 screwdriver, to remove two 3.0mm screws.

    • Remove the 4.0mm screw with a Phillips #000 screwdriver.

    • Using the blue plastic opening tool, remove the exterior cover.

    Editar

  7. Blu Grand M Speaker Replacement: paso 6, imagen 1 de 3 Blu Grand M Speaker Replacement: paso 6, imagen 2 de 3 Blu Grand M Speaker Replacement: paso 6, imagen 3 de 3

    • Use a Phillips #000 screwdriver to remove each of the four 1.5mm screws.

    • Use a Phillips #000 screwdriver to remove each of the three 3.0mm screws.

    • Use the plastic opening tool to remove the speaker.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 3 otros colaboradores

Cameron Retzlaff

Miembro Desde 09/17/18

608 Reputación

5 Guías creadas

Insignias: 9

+ 6 más insignias

Equipo

Washington State, Team S9-G2, Hope Fall 2018 Miembro de Washington State, Team S9-G2, Hope Fall 2018

WSU-HOPE-F18S9G2

3 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 5

Todo El Tiempo: 97