Introducción
The BlackMagic ATEM Television Studio Switcher has a terribly bad design with a loud fan. This procedure will help you upgrade your device to make is quiet.
WARNING - THIS WILL VOID YOUR WARRANTY!
Qué necesitas
Resumen del Video
-
-
Leave some length to solder with and to reach connector on main board.
-
-
-
-
Strip Wires, Tin Wires, and prep by adding heat shrink tubing on wires (before shrinking).
-
-
-
For Both Fans
-
Solder the new fan to the old connector using the following pinout.
-
Adjust heat shrink tubing so it covers the solder joints and use heat gun to shrink tubing.
-
-
-
Re-assemble fans to device with fan label facing out.
-
-
-
OPTIONAL - Use Small Round Nose Pliers to break off case grill to make fan even quieter.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
4 personas más completaron esta guía.
5 comentarios
I have an ATEM Production Studio 4K which had the same issue. This guide was helpful to know how to map the exhaust fan wiring. There are 2 12v heat sync fans that have the same color scheme. I just crimped the wires strait across, and everything worked. I’m now able to live edit without the distraction of a loud switch!
Thank you!!
I just did the same on my atem m/e production 4k but the side fans (exhaust) are not on. I wonder if there’s a threshold at which they power on? Any recommendation? The heat sink fans work right away.
Can I have a schematic diagram for this product ?
Awesome video, thanks! Do you have a similar iFixit kit and video for the ATEM Mini Pro?
