Introducción

This is a guide on how to replace the logic board on your Blackberry 7510.

Partes

No se requieren partes.

  1. Remove the battery cover and battery before continuing.
    • Remove the battery cover and battery before continuing.

    • Remove the six T6 Torx screws on the back of the phone.

    • Make sure to keep the screws somewhere that they will not get lost.

  2. Using your finger nail or a spudger, carefully pry up the back cover.
    • Using your finger nail or a spudger, carefully pry up the back cover.

    • Begin in one spot and slowly circle around the device as you pry up all of the back cover.

  3. Lift off the back cover.
    • Lift off the back cover.

  4. Remove the two T6 screws.
    • Remove the two T6 screws.

  5. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    We Are All Geniuses

    Share your repair story with #ImAGenius

  6. Remove the daughterboard. Remove the exposed vibration motor.
    • Remove the daughterboard.

    • Remove the exposed vibration motor.

  7. Using the T6 Torx screwdriver,  remove the top screw.
    • Using the T6 Torx screwdriver, remove the top screw.

  8. Using your spudger, carefully pry off back plate.
    • Using your spudger, carefully pry off back plate.

    • Use the same technique as with the plastic back cover. Circle around the back plate until all of it is pried up.

  9. Remove the front cover and keypad.
    • Remove the front cover and keypad.

  10. Remove one T6 Torx screw in the front bottom right of the board.
    • Remove one T6 Torx screw in the front bottom right of the board.

  11. Carefully pry the screen from the board with your spudger. After prying it up, remove the screen from the board.
    • Carefully pry the screen from the board with your spudger.

    • After prying it up, remove the screen from the board.

  12. Unscrew center T6 Torx screw in the center of the logic board. Remove the logic board from the phone.
    • Unscrew center T6 Torx screw in the center of the logic board.

    • Remove the logic board from the phone.

    • Replace with new logic board.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Neil Johnson

Miembro Desde 24/01/10

12 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 14-44, Regan Winter 2010 Miembro de Cal Poly, Team 14-44, Regan Winter 2010

CPSU-REGAN-W10S14G44

4 Miembros

8 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,784