Introducción

Use this guide to replace the keypad buttons of your BlackBerry 7290 .

  1. Apply pressure to the lock button on the back of the device.
    • Apply pressure to the lock button on the back of the device.

    • Slide the battery cover down towards the bottom of the device, revealing the battery compartment.

    Agregar Comentario

  2. Locate groove along the right side of the battery compartment.
    • Locate groove along the right side of the battery compartment.

    • Remove battery by prying between the battery and the groove.

    Agregar Comentario

    • Slide the SIM card holder to the left to unlock the SIM card.

    Agregar Comentario

    • Lift the SIM card holder up.

    • Gently remove the SIM card from the SIM card holder by sliding the card along the railing.

    Agregar Comentario

    • Locate the four screws along the perimeter of the back casing.

    • Remove the four top screws using a T-6 torx screwdriver.

    • The top four screws are .413 inches.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Locate two screws within the lower edge of the inner compartment.

    • Remove the two bottom screws using a T-6 torx screwdriver.

    • The bottom two screws are .2 inches in length.

    • The second picture displays the device after the six screws have been removed.

    Agregar Comentario

    • Use the plastic opening tool to apply pressure on the two clips that are located at the bottom of the phone.

    Agregar Comentario

    • Remove the back casing from the phone by lifting the unhooked portion, then slide the casing towards the top of the device.

    • Make sure all clips holding the case together are unhooked, so no damage is caused to the case.

    Agregar Comentario

    • Locate on the backside of the phone, a screw towards the top of the device.

    • Using a T-6 screwdriver, remove the screw.

    • After the screw has been removed, carefully lift the side button brace to reveal the side button.

    Agregar Comentario

    • To remove the phone's internals, start by loosening one side by pulling gently.

    Agregar Comentario

    • With one side loosened, simply lift the phone internals to separate from the front casing.

    Agregar Comentario

    • Turn the internals over to reveal the LCD display.

    Agregar Comentario

    • Peel off the rubber keypad buttons from the face plate.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

kmathew

Miembro Desde 17/10/09

3 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 19-6, Maness Fall 2009 Miembro de Cal Poly, Team 19-6, Maness Fall 2009

CPSU-MANESS-F09S19G6

5 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 3

Todo El Tiempo: 3,713