Repara tus cosas Comunidad Tienda

Black and Decker WP900 Power Switch Replacement

Introducción

This page gives instructions for disassembling the Black and Decker WP900 6-Inch Orbital Waxer and Polisher to the point where the on/off switch can be fully removed and replaced.

Qué necesitas

  1. Black and Decker WP900 Power Switch Replacement, Power Switch: paso 1, imagen 1 de 1

    • Using the plastic tool, detach the handle tab as shown.

    • Make sure the device is unplugged.

    Editar

  2. Black and Decker WP900 Power Switch Replacement: paso 2, imagen 1 de 1

    • Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.

    • Be sure to keep track of where each screw was placed in the device for later reassembly.

    Editar

  3. Black and Decker WP900 Power Switch Replacement: paso 3, imagen 1 de 3 Black and Decker WP900 Power Switch Replacement: paso 3, imagen 2 de 3 Black and Decker WP900 Power Switch Replacement: paso 3, imagen 3 de 3

    • Remove the back panel of the external casing, leaving all internal components resting in the front panel.

    • Remove the black handle from the main external casing.

    Editar

  5. Black and Decker WP900 Power Switch Replacement: paso 4, imagen 1 de 1

    • Loosen the power cord and control panel. Using the Phillip's #1 screwdriver, remove two 22mm screws.

    • The metal bracket will detach with the two screws.

    • Using the Flathead 3/32" screwdriver, remove two 22mm screws.

    Editar

  6. Black and Decker WP900 Power Switch Replacement: paso 5, imagen 1 de 2 Black and Decker WP900 Power Switch Replacement: paso 5, imagen 2 de 2

    • Gently pull the power cord out from the control module.

    • Remember, when reassembling the device, the black wire should be on the top

    Editar

  7. Black and Decker WP900 Power Switch Replacement: paso 6, imagen 1 de 1

    • Firmly grasping the motor, dislodge the internal components from the frontal external casing.

    • Switch and control panel will be attached to magnet body.

    Editar

  8. Black and Decker WP900 Power Switch Replacement: paso 7, imagen 1 de 1

    • Remove the switch from the wires.

    • Gently, pull and release the two wired connections.

    • The switch can now be replaced. Be sure not to damage the two connections to the control module in the process.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Cameron

Miembro Desde 02/15/16

231 Reputación

2 Guías creadas

Insignias: 12

+ 9 más insignias

Equipo

IUPUI, Team 8-8, Wilson Spring 2016 Miembro de IUPUI, Team 8-8, Wilson Spring 2016

IUPUI-WILSON-S16S8G8

4 Miembros

4 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 3

Todo El Tiempo: 975