Saltar al contenido principal

Introducción

This page gives instructions for disassembling the Black and Decker WP900 6-Inch Orbital Waxer and Polisher to where the external casing can be removed from all internal workings.

  1. Black and Decker WP900 Exterior Casing Replacement, Exterior Casing: paso 1, imagen 1 de 1
    • Using the plastic tool, detach the handle tab as shown.

    • Make sure the device is unplugged.

  2. Black and Decker WP900 Exterior Casing Replacement: paso 2, imagen 1 de 1
    • Using the Phillips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.

    • Be sure to keep track of where each screw was placed in the device for later reassembly.

  3. Black and Decker WP900 Exterior Casing Replacement: paso 3, imagen 1 de 3 Black and Decker WP900 Exterior Casing Replacement: paso 3, imagen 2 de 3 Black and Decker WP900 Exterior Casing Replacement: paso 3, imagen 3 de 3
    • Remove the back panel of the external casing, leaving all internal components resting in the front panel.

    • Remove the black handle from the main external casing.

  4. Black and Decker WP900 Exterior Casing Replacement: paso 4, imagen 1 de 1
    • Using the Phillips #1 screwdriver, remove the two 22mm screws.

    • The metal bracket will detach with the two screws.

    • Using the Flathead 3/32" screwdriver, remove two 22mm screws.

  5. Black and Decker WP900 Exterior Casing Replacement: paso 5, imagen 1 de 2 Black and Decker WP900 Exterior Casing Replacement: paso 5, imagen 2 de 2
    • Gently pull the power cord out from the control module.

    • Remember, when reassembling the device, the black wire should be on the top.

  6. Black and Decker WP900 Exterior Casing Replacement: paso 6, imagen 1 de 1
    • Firmly grasping the motor dislodge the internal components from the frontal external casing.

    • Once the motor has been removed, the external casing can now be replaced.

Conclusión

To reassemble your device, follow these instructions in reverse order.

David Hutchings

Miembro Desde 28/03/16

101 Reputación

1 Guía escrita

Equipo

IUPUI, Team 8-8, Wilson Spring 2016 Miembro de IUPUI, Team 8-8, Wilson Spring 2016

IUPUI-WILSON-S16S8G8

4 Miembros

4 Guías creadas

Un Comentario

Hello, this is Adam Kinnett from Group 7. You have done an excellent job on your photos as well as the descriptions and formatting.

**One of your Wiki pages on the search says "Back and Decker".

Adam Kinnett - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 3

Ultimos 30 días: 13

Todo El Tiempo: 618