Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the six 9.5mm screws on the back panel using a #2 Phillips screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 13mm screws, located between the feet on the bottom of the cover, using a Torx T15 screw driver.
-
On the TO1313SB, a Security Torx T15 driver is required — the screws have a center pin that prevents use of a regular T15 driver.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the metal spudger, carefully pry out the rubber base on each foot to access the screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 11.5 mm screws using a #2 Phillips screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the back cover by gently pulling the sides of the cover apart from the rest of the oven. Then, tilt the cover towards the face and pull back at an upward angle. The cover should slide right off.
-