Black and Decker TO1303SB Top Cover Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

In order to complete the other repairs, except for the control knobs, you will need to do this prerequisite. This prerequisite lets you have easy access to the inside of the toaster oven. Ultimately, this guide is created to remove the top cover.

Qué necesitas

Paso 1 Top Cover

Black and Decker TO1303SB Top Cover Replacement, Top Cover: paso 1, imagen 1 de 2

Black and Decker TO1303SB Top Cover Replacement, Top Cover: paso 1, imagen 2 de 2

Remove the six 9.5mm screws on the back panel using a #2 Phillips screwdriver.

Traducir

Paso 2

Remove the two 13mm screws, located between the feet on the bottom of the cover, using a Torx T15 screw driver.

Traducir

Paso 3

Using the metal spudger, carefully pry out the rubber base on each foot to access the screws.

Traducir

Paso 4

Remove the 11.5 mm screws using a #2 Phillips screwdriver.

Traducir

Paso 5

Remove the back cover by gently pulling the sides of the cover apart from the rest of the oven. Then, tilt the cover towards the face and pull back at an upward angle. The cover should slide right off.

Traducir