Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Use this guide to remove or replace the handle casing of your Black and Decker LI2000.

  1. Remove the following five screws Three 20 mm Phillips #1 screws One 10 mm #000 Phillips screw
    • Remove the following five screws

    • Three 20 mm Phillips #1 screws

    • One 10 mm #000 Phillips screw

    • One 13 mm Phillips 31 screw

    • When you remove the 13 mm screw, the spring may pop out of the screwdriver. Point the backside of the screwdriver away from your face and others.

  2. Remove the black sticker with recycling information.
    • Remove the black sticker with recycling information.

  3. ABRIR TODAS LAS PESTAÑAS

    Kits de actualización de RAM para Mac

    Compra kits

    Suficiente RAM
    para todas las pestañas

    Compra kits
  4. Use your fingers or a plastic opening tool to pry the casing apart.
    • Use your fingers or a plastic opening tool to pry the casing apart.

  5. Remove the plastic slider by picking it up off the screwdriver.
    • Remove the plastic slider by picking it up off the screwdriver.

    • You may consider leaving half of the casing on the screwdriver to make handling the screwdriver easier.

  6. Remove the four 15mm Phillips #1 screws. Remove the four 15mm Phillips #1 screws.
    • Remove the four 15mm Phillips #1 screws.

  7. Use a plastic opening tool to pry the casing apart. Use a plastic opening tool to pry the casing apart.
    • Use a plastic opening tool to pry the casing apart.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

IUPUI, Team 1-3, Baechle Spring 2016 Miembro de IUPUI, Team 1-3, Baechle Spring 2016

IUPUI-BAECHLE-S16S1G3

4 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 130