Black and Decker IR02V-T Power Cord Replacement

Introducción

This guide demonstrates how to replace a Black & Decker IR02V-T flat iron power cord. A guide like this is crucial because any internal damage to your power cord could lead to a short circuit and would ruin the flat iron.

When completing the process ensure the flatiron is unplugged and has completely cooled down.

Qué necesitas

Paso 1 Power Cord

Black and Decker IR02V-T Power Cord Replacement, Power Cord: paso 1, imagen 1 de 3

Black and Decker IR02V-T Power Cord Replacement, Power Cord: paso 1, imagen 2 de 3

Black and Decker IR02V-T Power Cord Replacement, Power Cord: paso 1, imagen 3 de 3

Remove the two silicone covers which encase the screws.
Remove both 1 mm screws using a T5 Torx screwdriver.
Pry open the plastic cover starting from the top of the iron.

Editar

Paso 2

Black and Decker IR02V-T Power Cord Replacement: paso 2, imagen 3 de 3

Remove both caps from the end of the wire by using pliers.
Unfold the metal in the caps using the pliers to release the exposed wire.
Remove the two 1 mm screws holding down the wire using a Phillips #00 screwdriver.
Once the wires are exposed separate and fold to opposite sides.

Editar

Paso 3

Black and Decker IR02V-T Power Cord Replacement: paso 3, imagen 3 de 3

Remove the old power cord from the iron completely.
Insert the new cord through the plastic cover and hole of the iron as demonstrated in the image.

Editar

Paso 4

Black and Decker IR02V-T Power Cord Replacement: paso 4, imagen 3 de 3

Expose about half an inch of wire by removing the silicone that encases it.
Tie the new wire into a knot and connect the wires accordingly.
Place the caps over the exposed wire and use pliers to tighten the metal to secure the wire.

Editar

Paso 5

Black and Decker IR02V-T Power Cord Replacement: paso 5, imagen 3 de 3

Once the caps are over the wires add the two 1 mm Phillips screws along with the small base plate which secures the wire.
When all wires are secure place the plastic cover and screw back in the 1mm Torx screws.

Editar