Introducción

Upon completion of this guide, you can successfully install and replace the motor fan for you blender.

Before disassembling the blender base, make sure the blender disconnected from any power outlet.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

Agregar Comentario

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

Agregar Comentario

  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

Agregar Comentario

  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

Agregar Comentario

  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Agregar Comentario

  • Using pliers, remove the top nut from the fan and remove the washer.

  • Use a small towel to hold the fan in place. This makes taking off the nut easier to do.

Agregar Comentario

  • Lift the fan blades from the blender base.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Andrew

Miembro Desde 04/10/12

170 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 6-34, Regan Fall 2012 Miembro de Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 5

Últimos 30 Días: 38

Todo El Tiempo: 2,467