Before disassembling the blender base, make sure the blender disconnected from any power outlet. Lift the jar straight up from the base without tilting the jar.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

Agregar Comentario

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

Agregar Comentario

Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver. This provides access to the base screws beneath.
  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

Agregar Comentario

Remove the following screws that secure the top and  bottom halves of the base.
  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

Agregar Comentario

Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.
  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Agregar Comentario

Once you have the base removed, the circuit board should be clearly visible inside.
  • Once you have the base removed, the circuit board should be clearly visible inside.

Agregar Comentario

Remove the four screws located on the circuit board. Two are on the left side.
  • Remove the four screws located on the circuit board.

    • Two are on the left side.

    • Two are on the right side.

Agregar Comentario

Remove the following soldered connections with a soldering iron:
  • Remove the following soldered connections with a soldering iron:

    • Motor wires

    • Power cord wires

Agregar Comentario

Lift the circuit board straight up to remove it from the base.
  • Lift the circuit board straight up to remove it from the base.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Andrew

Miembro Desde 04/10/12

170 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 6-34, Regan Fall 2012 Miembro de Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 1

Últimos 30 Días: 41

Todo El Tiempo: 2,597