Introducción

The Bissell Pet Hair Eraser vacuum motor may have issues. This is a guide to replacing the vacuum motor.

Partes

No se requieren partes.

  1. Firmly grasp the handle and press the release button.
    • Firmly grasp the handle and press the release button.

    • Gently pull the dirt cup down and away from the vacuum body.

  2. Remove the six 1.2 mm Philips #2 screws in the shown locations.
    • Remove the six 1.2 mm Philips #2 screws in the shown locations.

    • Grasp each half of the body and gently pull apart.

    • The green handle, power button, charge light lens, and dirt cup release are not fastened in place.

    • Once the case is split apart these items may come dislodged.

    • The power button can be removed by gently lifting it off the circuitry.

    • Remove the battery plastic hold down by lifting it off the tabs.

    • Remove the battery by lifting straight up.

    • Position the battery aside.

    • Grasp the charger port and remove it by lifting it straight out of the case.

    • Set the charger port next to the battery.

    • Remove the power button and charge LED light by gently pulling straight out of the case.

    • The vacuum motor can be removed by pulling straight out of the case.

    • All internals are now removed.

    • Set the case halves aside.

    • Remove the two 1 mm Phillips #2 screws in the shown locations.

    • Disconnect the power leads from the vacuum motor.

    • The red power lead goes on the terminal with the visible red dot.

    • Grasp the vacuum motor and housing and pull them apart.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 23

Todo El Tiempo: 55