Repara tus cosas Comunidad Tienda

Bell and Howell DNV16HDZ Hand Strap Replacement

Qué necesitas

  1. Bell and Howell DNV16HDZ Hand Strap Replacement, Lens Assembly: paso 1, imagen 1 de 2 Bell and Howell DNV16HDZ Hand Strap Replacement, Lens Assembly: paso 1, imagen 2 de 2

    • Remove the five 30mm Phillips #0 screws on the bottom of the camera.

    Editar

  2. Bell and Howell DNV16HDZ Hand Strap Replacement: paso 2, imagen 1 de 1

    • Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.

    • Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

    Editar

  4. Bell and Howell DNV16HDZ Hand Strap Replacement: paso 3, imagen 1 de 1

    • It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

    Editar

  5. Bell and Howell DNV16HDZ Hand Strap Replacement, Hand Strap: paso 4, imagen 1 de 2 Bell and Howell DNV16HDZ Hand Strap Replacement, Hand Strap: paso 4, imagen 2 de 2

    • Pull the side with the hand strap upwards to disconnect it from the camcorder.

    • Unscrew the four 40 mm Phillips #0 screws.

    • Add the new hand strap now.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Jerry Hadjah

Miembro Desde 03/04/16

525 Reputación

5 Guías creadas

Insignias: 10

+ 7 más insignias

Equipo

UMass Dartmouth, Team 8-4, Botvin Spring 2016 Miembro de UMass Dartmouth, Team 8-4, Botvin Spring 2016

UMASSD-BOTVIN-S16S8G4

3 Miembros

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 5

Todo El Tiempo: 189