Saltar al contenido principal

Black and Decker SS12C Battery Replacement

Qué necesitas

  1. Black and Decker SS12C Battery Replacement, Battery: paso 1, imagen 1 de 3 Black and Decker SS12C Battery Replacement, Battery: paso 1, imagen 2 de 3 Black and Decker SS12C Battery Replacement, Battery: paso 1, imagen 3 de 3
    • Detach the battery unit from the drill by pressing down on the battery release button and pulling the battery towards you.

  2. Black and Decker SS12C Battery Replacement: paso 2, imagen 1 de 1
    • Now that the battery component is detached, remove the 4 screws indicated [16mm].

    • Remove each screw with the T10 Torx Security Bit Screwdriver by turning counterclockwise.

  3. Black and Decker SS12C Battery Replacement: paso 3, imagen 1 de 3 Black and Decker SS12C Battery Replacement: paso 3, imagen 2 de 3 Black and Decker SS12C Battery Replacement: paso 3, imagen 3 de 3
    • Now that the screws are detached, separate the two sides of the battery.

  4. Black and Decker SS12C Battery Replacement: paso 4, imagen 1 de 2 Black and Decker SS12C Battery Replacement: paso 4, imagen 2 de 2
    • Remove the highlighted, orange component and set aside.

  5. Black and Decker SS12C Battery Replacement: paso 5, imagen 1 de 3 Black and Decker SS12C Battery Replacement: paso 5, imagen 2 de 3 Black and Decker SS12C Battery Replacement: paso 5, imagen 3 de 3
    • Grip the battery pack and detach it from the casing by pulling it upward.

    • Spring may fall out during the process.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Un comentario

I have a CD 9600 Type 3 with a B&D PS120 pack. are there any replacement packs available? Thanks!

Scott D. Deutsch - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 7

Todo El Tiempo: 823