Repara tus cosas Comunidad Tienda

Basis B1 Band LED Screen Replacement

Introducción

This guide shows how to replace the LED screen. This is a more complicated guide because it involves removing the back plate of the watch along with the battery.

Qué necesitas

  1. Basis B1 Band LED Screen Replacement, Watch Strap: paso 1, imagen 1 de 1

    • Wedge a plastic opening tool between band contacts.

    Traducir

  2. Basis B1 Band LED Screen Replacement: paso 2, imagen 1 de 1

    • Push in plastic opening tool until the components click and pop out of the holder.

    • Repeat steps for other band.

    Traducir

  3. Basis B1 Band LED Screen Replacement, Back Plate: paso 3, imagen 1 de 1

    • Remove four 4mm screws using a PH000 screwdriver.

    • Remove back plate.

    Traducir

  4. Basis B1 Band LED Screen Replacement, Battery: paso 4, imagen 1 de 1

    • Use tweezers to remove elastomeric, or zebra, connector.

    Traducir

  6. Basis B1 Band LED Screen Replacement: paso 5, imagen 1 de 2 Basis B1 Band LED Screen Replacement: paso 5, imagen 2 de 2

    • Use the flat end of the spudger to carefully lift the battery until adhesive seal is broken.

    Traducir

  7. Basis B1 Band LED Screen Replacement: paso 6, imagen 1 de 1

    • Use the pointy edge of the spudger tool to detach battery leads from the circuit board.

    Traducir

  8. Basis B1 Band LED Screen Replacement, LED Screen: paso 7, imagen 1 de 2 Basis B1 Band LED Screen Replacement, LED Screen: paso 7, imagen 2 de 2

    • Use PH000 screw driver to remove two 6mm bracketed screws.

    • Remove bracket.

    Traducir

  9. Basis B1 Band LED Screen Replacement: paso 8, imagen 1 de 1

    • Use PH000 tool to remove two 4mm screws.

    Traducir

  10. Basis B1 Band LED Screen Replacement: paso 9, imagen 1 de 1
    Traducir

  11. Basis B1 Band LED Screen Replacement: paso 10, imagen 1 de 1

    • Use spudger tool to lift the clasp of LED connector strip and remove from watch case.

    Traducir

  12. Basis B1 Band LED Screen Replacement: paso 11, imagen 1 de 1

    • Use spudger tool to remove the LED screen from the watch case.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Kaitlyn Lee

Miembro Desde 11/06/17

518 Reputación

4 Guías creadas

Insignias: 7

+ 4 más insignias

Equipo

IUPUI, Team S6-G1, Baechle Fall 2017 Miembro de IUPUI, Team S6-G1, Baechle Fall 2017

IUPUI-BAECHLE-F17S6G1

4 Miembros

4 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 200