Repara tus cosas Comunidad Tienda

BLU Life XL Charging Port Replacement

Introducción

Replacing the charging port on your BLU Life XL device is an effective method of attempting repair of charging issue. This guide shows how one may replace the internal lower PCB unit, where the charging port is located.

Qué necesitas

  1. BLU Life XL Charging Port Replacement, Battery: paso 1, imagen 1 de 3 BLU Life XL Charging Port Replacement, Battery: paso 1, imagen 2 de 3 BLU Life XL Charging Port Replacement, Battery: paso 1, imagen 3 de 3

    • Turn the device off by holding down the power button for up to 5 seconds and then tapping the "Power off" button on the screen.

    • Remove the rear cover using your hands at the lip on the device back cover. No tools required.

    Editar

  2. BLU Life XL Charging Port Replacement: paso 2, imagen 1 de 3 BLU Life XL Charging Port Replacement: paso 2, imagen 2 de 3 BLU Life XL Charging Port Replacement: paso 2, imagen 3 de 3

    • Remove the old battery.

    • For optimal performance, calibrate your newly installed battery: Drain battery below 10%, then charge uninterrupted to 100%.

    Editar

  4. BLU Life XL Charging Port Replacement, Charging Port: paso 3, imagen 1 de 2 BLU Life XL Charging Port Replacement, Charging Port: paso 3, imagen 2 de 2

    • Remove twelve 3mm Phillips #000 screws from the rear plate.

    Editar

  5. BLU Life XL Charging Port Replacement: paso 4, imagen 1 de 2 BLU Life XL Charging Port Replacement: paso 4, imagen 2 de 2

    • Remove the plastic frame on the device using an opening tool.

    • Firmly press the tool into the gap between the front glass and rear plate.

    • The gap is located on all sides of the phone.

    • Run the tool through this gap along the entire edge of the phone to separate the plastic frame from the phone.

    Editar

  6. BLU Life XL Charging Port Replacement: paso 5, imagen 1 de 3 BLU Life XL Charging Port Replacement: paso 5, imagen 2 de 3 BLU Life XL Charging Port Replacement: paso 5, imagen 3 de 3

    • Disconnect lower PCB antenna connection.

    • Disconnect lower PCB data cable connection.

    • Remove the single JIS #000 3mm screw from the PCB board.

    Editar

  7. BLU Life XL Charging Port Replacement: paso 6, imagen 1 de 1

    • Remove the haptic motor at bottom left of the device. This will require a prying tool, as the motor is glued to the device.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 6 otros colaboradores

Euan Gordon

Miembro Desde 02/14/18

164 Reputación

1 Guía escrita

Insignias: 8

+ 5 más insignias

Equipo

USF Tampa, Team S2-G5, Eyestone Spring 2018 Miembro de USF Tampa, Team S2-G5, Eyestone Spring 2018

USFT-EYESTONE-S18S2G5

3 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 7

Ultimos 30 días: 14

Todo El Tiempo: 1,924