Repara tus cosas Comunidad Tienda

BLU Dash JR D140 Digitizer Replacement

Introducción

Screens on these phones can crack easily, using this guide you can have a clean brand new slick look again! It is also a nice way to get under the screen and remove dust particles.

Qué necesitas

  1. BLU Dash JR D140 Digitizer Replacement, Battery: paso 1, imagen 1 de 1

    • Turn off the phone first. Press the power button continuously for 2-3 seconds to shut down the phone.

    • Using a plastic opening tool, pry open the back cover from the slit on the bottom right corner of the phone.

    Traducir

  2. BLU Dash JR D140 Digitizer Replacement: paso 2, imagen 1 de 1

    • Using a plastic opening tool or finger, pull out the battery.

    Traducir

  3. BLU Dash JR D140 Digitizer Replacement, Digitizer: paso 3, imagen 1 de 1

    • Remove the four 4.0mm Phillips #1 screws.

    Traducir

  4. BLU Dash JR D140 Digitizer Replacement: paso 4, imagen 1 de 1

    • Starting from a corner, separate the panel from the frame using the plastic opening tool.

    • The volume button will pop out.

    Traducir

  6. BLU Dash JR D140 Digitizer Replacement: paso 5, imagen 1 de 1

    • Unscrew the 3.6mm Phillips #0 screw from the motherboard.

    Traducir

  7. BLU Dash JR D140 Digitizer Replacement: paso 6, imagen 1 de 1

    • Using a spudger, lift the black ZIF connector at the top left corner of the phone.

    Traducir

  8. BLU Dash JR D140 Digitizer Replacement: paso 7, imagen 1 de 1

    • Pull the ribbon cable out of the ZIF connector.

    Traducir

  9. BLU Dash JR D140 Digitizer Replacement: paso 8, imagen 1 de 1

    • When the ribbon cable is removed from the ZIF connector, peel off the power, sticky button using a plastic opening tool.

    Traducir

  10. BLU Dash JR D140 Digitizer Replacement: paso 9, imagen 1 de 1

    • Peel off the volume sticky button.

    Traducir

  11. BLU Dash JR D140 Digitizer Replacement: paso 10, imagen 1 de 2 BLU Dash JR D140 Digitizer Replacement: paso 10, imagen 2 de 2

    • Separate the screen cover from the motherboard using the plastic opening tool. And don't forget that your phone can mess up if u separate the motherboard from the screen cover

    • Make sure that the LCD screen stays attached to the motherboard while doing this.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Autor

con 6 otros colaboradores

Nathanael

Miembro Desde 07/23/15

233 Reputación

1 Guía escrita

Insignias: 9

+ 6 más insignias

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 1

Ultimos 30 días: 5

Todo El Tiempo: 1,196