Repara tus cosas Comunidad Tienda

August Smart Lock Speaker Replacement

Introducción

This guide will teach you how to replace the speaker that are located within the device. The speaker can malfunction causing you to not hear the proper sounds from the lock.

Qué necesitas

  1. August Smart Lock Speaker Replacement, Speaker: paso 1, imagen 1 de 3 August Smart Lock Speaker Replacement, Speaker: paso 1, imagen 2 de 3 August Smart Lock Speaker Replacement, Speaker: paso 1, imagen 3 de 3

    • Flip the device so the back cover is facing you.

    • Undo the latches on both sides to remove the metal cover.

    • Using a Phillips #0 screwdriver, remove the black screws to release the back cover.

    • To unscrew all of the screws, you will need to close the latches again.

    • Do not pull the cover apart too far as the speaker is in the cover and connected to the motherboard.

    Editar

  2. August Smart Lock Speaker Replacement: paso 2, imagen 1 de 3 August Smart Lock Speaker Replacement: paso 2, imagen 2 de 3 August Smart Lock Speaker Replacement: paso 2, imagen 3 de 3

    • Use the metal spudger to pry the plug off of the motherboard.

    • The plug can be dislodged when prying it from the side.

    Editar

  4. August Smart Lock Speaker Replacement: paso 3, imagen 1 de 3 August Smart Lock Speaker Replacement: paso 3, imagen 2 de 3 August Smart Lock Speaker Replacement: paso 3, imagen 3 de 3

    • Warm up the iOpener.

    • Do not place the iOpener in microwave for more than 30 seconds.

    • Place the iOpener heating pad over the speaker and let sit for a few moments.

    • Using the metal spudger, pry some of the glue off the hinges holding the speaker in place.

    Editar

  5. August Smart Lock Speaker Replacement: paso 4, imagen 1 de 2 August Smart Lock Speaker Replacement: paso 4, imagen 2 de 2

    • Once the speaker looks mobile, flip the cover over and push below the speaker to pop it out.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 1 otro colaborador

William Fink

Miembro Desde 09/26/17

766 Reputación

3 Guías creadas

Insignias: 11

+ 8 más insignias

Equipo

USF Tampa, Team S11-G6, Passmore Fall 2017 Miembro de USF Tampa, Team S11-G6, Passmore Fall 2017

USFT-PASSMORE-F17S11G6

4 Miembros

3 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 10

Todo El Tiempo: 1,440