Saltar al contenido principal

Audiovox CDM-8910 LCD Screen Replacement

Qué necesitas

  1. Audiovox CDM-8910 LCD Screen Replacement, LCD Screen: paso 1, imagen 1 de 1
    • With phone in the flipped-open position, use a spudger to remove the four (4) rubber pads (one shown in red circle) located near the corners of the face with the LCD screen.

  2. Audiovox CDM-8910 LCD Screen Replacement: paso 2, imagen 1 de 1
    • Use a small Phillips head screwdriver to remove the four (4) screws exposed by removed rubber pads.

  3. Audiovox CDM-8910 LCD Screen Replacement: paso 3, imagen 1 de 1
    • Use a spudger to pry the front cover off of the phone, gradually working your way around the front face.

  4. Audiovox CDM-8910 LCD Screen Replacement: paso 4, imagen 1 de 1
    • Use a spudger to lift away and remove the metallic frame (in blue).

    • Use the spudger to lift away the two electrical contacts (in red).

    • Use the spudger to lift away the speaker (in yellow).

  5. Audiovox CDM-8910 LCD Screen Replacement: paso 5, imagen 1 de 1
    • This is what the rear of the LCD screen should look like before proceeding. Note all necessary connections are undone.

  6. Audiovox CDM-8910 LCD Screen Replacement: paso 6, imagen 1 de 1
    • Use a spudger to lift away the LCD screen.

  7. Audiovox CDM-8910 LCD Screen Replacement: paso 7, imagen 1 de 1
    • LCD screen successfully removed!

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Kevin Jafarey

Miembro Desde 10/04/10

11 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 3-24, Regan Fall 2010 Miembro de Cal Poly, Team 3-24, Regan Fall 2010

CPSU-REGAN-F10S3G24

4 Miembros

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 2,891