Introducción

The LCD screen is the main display of the Audiovox CDM-8910.

Partes

No se requieren partes.

With phone in the flipped-open position, use a spudger to remove the four (4) rubber pads (one shown in red circle) located near the corners of the face with the LCD screen.
  • With phone in the flipped-open position, use a spudger to remove the four (4) rubber pads (one shown in red circle) located near the corners of the face with the LCD screen.

Agregar Comentario

Use a small Phillips head screwdriver to remove the four (4) screws exposed by removed rubber pads.
  • Use a small Phillips head screwdriver to remove the four (4) screws exposed by removed rubber pads.

Agregar Comentario

  • Use a spudger to pry the front cover off of the phone, gradually working your way around the front face.

Agregar Comentario

  • Use a spudger to lift away and remove the metallic frame (in blue).

  • Use the spudger to lift away the two electrical contacts (in red).

  • Use the spudger to lift away the speaker (in yellow).

Agregar Comentario

  • This is what the rear of the LCD screen should look like before proceeding. Note all necessary connections are undone.

Agregar Comentario

  • Use a spudger to lift away the LCD screen.

Agregar Comentario

  • LCD screen successfully removed!

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Kevin Jafarey

Miembro Desde 04/10/10

11 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 3-24, Regan Fall 2010 Miembro de Cal Poly, Team 3-24, Regan Fall 2010

CPSU-REGAN-F10S3G24

4 Miembros

12 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 2

Todo El Tiempo: 2,758