Saltar al contenido principal

Introducción

This is how to remove the 5 screws and pry the logic board free.

Partes

No se especificaron partes.

  1. Hold the phone in one hand, slide the latch up, and pull the battery up to remove it. Hold the phone in one hand, slide the latch up, and pull the battery up to remove it.
    • Hold the phone in one hand, slide the latch up, and pull the battery up to remove it.

  2. Grasp the antenna at its base and twist to unscrew. Remove the antenna along with its plastic casing from inside the battery housing. Keep the antenna in the plastic casing for reassembly. Remove the antenna along with its plastic casing from inside the battery housing. Keep the antenna in the plastic casing for reassembly.
    • Grasp the antenna at its base and twist to unscrew.

    • Remove the antenna along with its plastic casing from inside the battery housing. Keep the antenna in the plastic casing for reassembly.

  3. Remove the small rubber insert from the top of the phone to access the top screw. Unscrew all five screws on the back of the cell phone with a Phillips #00 screwdriver. If screws do not slide out after unscrewing, gently flip and tap the phone in your hand until the screws come loose.
    • Remove the small rubber insert from the top of the phone to access the top screw.

    • Unscrew all five screws on the back of the cell phone with a Phillips #00 screwdriver.

    • If screws do not slide out after unscrewing, gently flip and tap the phone in your hand until the screws come loose.

  4. Wedge the phone plate toward you, using the leverage from an opening tool. The volume control button on the left side of the phone will loosen. Make sure to carefully reinsert it during reassembly. Detach the motherboard from the LCD screen connector by gently detaching the small copper plate on the top right of the motherboard.
    • Wedge the phone plate toward you, using the leverage from an opening tool.

    • The volume control button on the left side of the phone will loosen. Make sure to carefully reinsert it during reassembly.

    • Detach the motherboard from the LCD screen connector by gently detaching the small copper plate on the top right of the motherboard.

  5. To release the motherboard, push the large "OK" button located on the other side of the phone. Before reassembly, make sure the keypad is lined up with the motherboard. Be sure the camera lens is properly aligned at the top of the motherboard and the volume controls are in place. Before reassembly, make sure the keypad is lined up with the motherboard. Be sure the camera lens is properly aligned at the top of the motherboard and the volume controls are in place.
    • To release the motherboard, push the large "OK" button located on the other side of the phone.

    • Before reassembly, make sure the keypad is lined up with the motherboard. Be sure the camera lens is properly aligned at the top of the motherboard and the volume controls are in place.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Aaron Shaw

Miembro Desde 15/04/10

150 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 28-31, Regan Spring 2010 Miembro de Cal Poly, Team 28-31, Regan Spring 2010

CPSU-REGAN-S10S28G31

4 Miembros

12 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 2,672