Introducción

This is how to remove the 5 screws and pry the logic board free.

Partes

No se requieren partes.

  1. Hold the phone in one hand, slide latch, and pull to remove the battery.
    • Hold the phone in one hand, slide latch, and pull to remove the battery.

    Agregar Comentario

  2. Grasp antenna at its base and unscrew.
    • Grasp antenna at its base and unscrew.

    • Remove the antenna along with its plastic casing from inside the battery housing. Keep the antenna in the plastic casing for reassembly.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove small rubber insert from top of phone to access the top screw.

    • Warning: Screws are very small and may be difficult to see while unscrewing.

    • Unscrew all five (5) screws on the back of cell phone.

    • If screws do not remove after fully unthreading, gently invert and tap phone in hand until the screws come loose.

    Agregar Comentario

    • Wedge back plate away from cell phone using the leverage from the plastic spudger.

    • The volume control button on the left side of the phone will be loose. Make sure to carefully reinsert during reassembly.

    • Detach logic board from LCD screen connector by gently detaching the small copper plate on the top right of the logic board. (shown circled in blue and detached)

    Agregar Comentario

    • Pop the logic board out from the front of the cell phone.

    • Before reassembly, be sure keypad is lined up with logic board.

    • Before reassembly, be sure camera lens is properly aligned at the top of the logic board and volume controls are in place.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Aaron Shaw

Miembro Desde 15/04/10

150 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 28-31, Regan Spring 2010 Miembro de Cal Poly, Team 28-31, Regan Spring 2010

CPSU-REGAN-S10S28G31

4 Miembros

12 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 3

Todo El Tiempo: 2,589