Repara tus cosas Comunidad Tienda

Atari Lynx Backlight Replacement

Introducción

Before starting this guide you may need some experience with soldering/ desoldering. If you do not know how, you can learn by clicking the link we put on step 8 (when you have to desolder the backlight).

Qué necesitas

  1. Atari Lynx Backlight Replacement, Atari Lynx: paso 1, imagen 1 de 1

    • Before disassembling your Atari Lynx, be sure the device is powered off.

    • Remove any game in the console by opening the right latch and sliding the game to the right.

    Editar

  2. Atari Lynx Backlight Replacement: paso 2, imagen 1 de 1

    • Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.

    • Pinch the rear panel with your fingers and lift away from the Atari.

    Editar

  3. Atari Lynx Backlight Replacement: paso 3, imagen 1 de 1

    • Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.

    • Be sure not to tear any wires attached to battery panel.

    Editar

  5. Atari Lynx Backlight Replacement: paso 4, imagen 1 de 1

    • Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.

    • Be sure not to tear the speaker wire while removing the control panel.

    Editar

  6. Atari Lynx Backlight Replacement, Backlight: paso 5, imagen 1 de 1

    • Pull out the logic-board.

    • Pull to the sides the four rubber tabs holding in the screen

    Editar

  7. Atari Lynx Backlight Replacement: paso 6, imagen 1 de 1

    • Unscrew the two 10 mm screws as shown with a Phillips #0 screwdriver in order to remove the shield behind the backlight.

    Editar

  8. Atari Lynx Backlight Replacement: paso 7, imagen 1 de 1

    • Flip over the motherboard and remove the shield behind the backlight.

    Editar

  9. Atari Lynx Backlight Replacement: paso 8, imagen 1 de 2 Atari Lynx Backlight Replacement: paso 8, imagen 2 de 2

    • Flip the motherboard back over and desolder the two components that are holding the backlight in place.

    • If you need help with basic desoldering, click here.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Autor

con 5 otros colaboradores

John Lopez

Miembro Desde 01/27/14

443 Reputación

4 Guías creadas

Insignias: 9

+ 6 más insignias

Equipo

Cal Poly, Team 1-42, Maness Winter 2014 Miembro de Cal Poly, Team 1-42, Maness Winter 2014

CPSU-MANESS-W14S1G42

5 Miembros

16 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 5

Ultimos 30 días: 23

Todo El Tiempo: 4,343