Saltar al contenido principal

Introducción

If the button on an Atari Flashback 2 console is sticking or broken, then it will need to be cleaned or replaced. This guide covers the steps necessary to disassemble the console in order to access the buttons to do so.

Partes

No se especificaron partes.

  1. Using the screwdriver and the PH1 bit, unscrew the five 10.0 mm screws on the bottom of the console. One screw is under the main sticker in the middle of the console. One screw is under the main sticker in the middle of the console.
    • Using the screwdriver and the PH1 bit, unscrew the five 10.0 mm screws on the bottom of the console.

    • One screw is under the main sticker in the middle of the console.

  2. Unscrew the six 9.0 mm Phillips #1 screws on the brown circuit board that correspond to the reset and select buttons. Remove gently. The circuit board is connected by wire to the console. Removing the cable from the console case may allow more slack. Remove gently. The circuit board is connected by wire to the console. Removing the cable from the console case may allow more slack.
    • Unscrew the six 9.0 mm Phillips #1 screws on the brown circuit board that correspond to the reset and select buttons.

    • Remove gently. The circuit board is connected by wire to the console. Removing the cable from the console case may allow more slack.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

Good night! I have a flashback2 atari which burst the capacitor EC1, could you help me with its value? Thank you!

pradose - Contestar

Hi pradose! We no longer have the device so it will not be possible for our team to walk you through anything beyond the guides we posted.

Daniel Hoffman - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 2

Últimos 30 Días: 9

Todo El Tiempo: 117