Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y Herramientas

Introducción

Asus ZenWatch 2 users can set the watch to vibration mode if they want to receive notifications without an audible alert. The main component for this setting is the vibration motor housed within the casing of the watch. If the Asus ZenWatch 2 stops vibrating, this guide shows users how to replace it.

  1. Remove the watch strap by sliding the knob inward to detach from the face plate.
    • Remove the watch strap by sliding the knob inward to detach from the face plate.

  2. Open the watch by removing the four 3.5mm screws using the T5 screwdriver. Open the watch by removing the four 3.5mm screws using the T5 screwdriver.
    • Open the watch by removing the four 3.5mm screws using the T5 screwdriver.

  3. Place the spudger under the vibration motor and lift up to remove it from the watch. Place the spudger under the vibration motor and lift up to remove it from the watch.
    • Place the spudger under the vibration motor and lift up to remove it from the watch.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Andrew

Miembro Desde 20/02/17

302 Reputación

2 Guías creadas

Equipo

USF Tampa, Team S1-G1, Leahy Spring 2017 Miembro de USF Tampa, Team S1-G1, Leahy Spring 2017

USFT-LEAHY-S17S1G1

3 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 4

Ultimos 30 días: 12

Todo El Tiempo: 546