Saltar al contenido principal

Introducción

The Asus X751MA-DH01TQ has a built in webcam that is easy to access with this guide.

  1. Turn the laptop upside down and locate the ten screws that hold the plate cover. Remove all ten screws using a 00 Phillips head screwdriver.
    • Turn the laptop upside down and locate the ten screws that hold the plate cover.

    • Remove all ten screws using a 00 Phillips head screwdriver.

  2. Using the plastic opening tool, pry the keyboard off of the base of the laptop. Lift up and remove the keyboard.
    • Using the plastic opening tool, pry the keyboard off of the base of the laptop.

    • Lift up and remove the keyboard.

  3. Remove eight 4.4 Phillips #00 screws attached to the hinge. Hold the screen so it wont fall over. Hold the screen so it wont fall over.
    • Remove eight 4.4 Phillips #00 screws attached to the hinge.

    • Hold the screen so it wont fall over.

  4. Kits de reparación de iPhone X

    ¿Garantía vencida? No te preocupes, tenemos la solución.

    Comprar Ahora

    Kits de reparación de iPhone X

    ¿Garantía vencida? No te preocupes, tenemos la solución.

    Comprar Ahora
  5. Remove the stickers from the bottom left and right corners of the screen. Use a 00 Phillips head screw driver to remove the four screws. Use a 00 Phillips head screw driver to remove the four screws.
    • Remove the stickers from the bottom left and right corners of the screen.

    • Use a 00 Phillips head screw driver to remove the four screws.

  6. Use the plastic opening tool to take the screen apart.
    • Use the plastic opening tool to take the screen apart.

  7. Remove the two 4mm Phillips #00 screws attached to the webcam. Remove the two 4mm Phillips #00 screws attached to the webcam.
    • Remove the two 4mm Phillips #00 screws attached to the webcam.

  8. Slowly pull up the webcam out of its slot, and begin to remove the wire. Slowly pull up the webcam out of its slot, and begin to remove the wire. Slowly pull up the webcam out of its slot, and begin to remove the wire.
    • Slowly pull up the webcam out of its slot, and begin to remove the wire.

  9. Continue to unravel the wire and peel the webcam wire sticker off. Continue to unravel the wire and peel the webcam wire sticker off.
    • Continue to unravel the wire and peel the webcam wire sticker off.

  10. Once the sticker is peeled off pull the plug holding the webcam into the circuit board and the webcam is now disconnected. Once the sticker is peeled off pull the plug holding the webcam into the circuit board and the webcam is now disconnected.
    • Once the sticker is peeled off pull the plug holding the webcam into the circuit board and the webcam is now disconnected.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 70