Saltar al contenido principal

Introducción

This guide will demonstrate the process for replacing the RAM in this laptop. This could be useful if your RAM is not working properly or if you would like to upgrade your RAM. This will be one of the easiest replacements in this device. RAM is designed to be replaced and upgraded, so it was made very easy to access. RAM is basically the computer's temporary memory, NOT the computer's storage. One thing to note, this bay may be empty as one stick of RAM is soldered into the motherboard and is not serviceable by the end-user. If it is this stick that is defective, you will need to file an RMA. However if it is the stick in the bay that is defective, then please proceed with this repair guide.

Partes

No se especificaron partes.

  1. Flip your laptop upside down and set it on a solid surface.
    • Flip your laptop upside down and set it on a solid surface.

    • The RAM is located under the square cover on the bottom of the laptop.

  2. Use the plastic opening tool to remove the screw cover.
    • Use the plastic opening tool to remove the screw cover.

    • Make sure to keep the screw cover in a safe place. It is very easy to misplace.

  3. Using a #0 Phillips screwdriver, unscrew the single 2.5mm screw on the RAM cover.
    • Using a #0 Phillips screwdriver, unscrew the single 2.5mm screw on the RAM cover.

  4. Use the plastic opening tool to open the RAM cover.
    • Use the plastic opening tool to open the RAM cover.

  5. With your finger, push the two metal tabs (one on each side) outward until the RAM card pops up.
    • With your finger, push the two metal tabs (one on each side) outward until the RAM card pops up.

  6. Gently remove the RAM card.
    • Gently remove the RAM card.

Conclusión

To reassemble your device, follow these instructions in reverse order.

12 personas más completaron esta guía.

Why does my cover not have a screw? Same laptop, ASUS X555LA.

Bob - Contestar

Are you seeing just a plastic circle? That has to be pried off... the screw is underneath.

sakichri - Contestar

Hi! The battery have not be removed before this?

Ariel Bova - Contestar

Ariel, the battery should be removed but this creates very unnecessary strain and stress on you. This is just an expansion bay, the actual ram is soldered on the motherboard, not serviceable by the end-user. Again, this is an expansion bay so what that means is if no RAM is in the to begin with, the laptop will be fine because there is still RAM directly on the motherboard. This is just so the end-user can add more RAM if they so choose.

Ryan S. - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 6

Últimos 7 Días: 24

Últimos 30 Días: 136

Todo El Tiempo: 12,992