Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the device over so that the back cover is facing you.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 5mm Phillips #1 screws from the top of the laptop.
-
Remove the two 6mm Phillips #1 screws from the sides of the laptop.
-
Remove the four 2mm Phillips #1 screws from the bottom of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool to gently pry the bottom of the laptop up. Slowly slide it along the edges, twisting it every so often to pop the bottom of the laptop out of the clips holding it in place.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift off the cover and remove the back cover from the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #1 Screwdriver remove the three 3 mm black screws and four 2 mm copper screws holding the fan and heat sink in place.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the wire connecting the fan to the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently remove the fan and heat sink from the motherboard.
-