Saltar al contenido principal

Asus VivoBook X540SA-BPD0602V Battery Removal

Qué necesitas

  1. Asus VivoBook X540SA-BPD0602V Battery Removal, Keyboard: paso 1, imagen 1 de 1
    • Power down the laptop using the device's power button in top right corner of the keyboard. Ensure that the device's power cord is disconnected.

  2. Asus VivoBook X540SA-BPD0602V Battery Removal: paso 2, imagen 1 de 1
    • Flip the laptop over so the back panel is displayed.

  3. Asus VivoBook X540SA-BPD0602V Battery Removal: paso 3, imagen 1 de 1
    • Using a Phillips #1 screwdriver, remove the ten screws from the back panel.

    • Remove the two battery screws (15.6 mm)

    • Two top corner screws (12.5 mm)

    • Six case screws (9.7mm)

  4. Asus VivoBook X540SA-BPD0602V Battery Removal: paso 4, imagen 1 de 1
    • Flip the laptop back over and open it, revealing the screen and keyboard.

  5. Asus VivoBook X540SA-BPD0602V Battery Removal: paso 5, imagen 1 de 1
    • Using the blue plastic opening tool, wedge and loosen the seal all the way around the edges. Carefully lift up the keyboard panel.

    • When lifting the keyboard panel, do not lift it all the way as the two connection ribbons to the motherboard must be disconnected.

    • It is recommended to break the seal of the case starting at the upper corners closest to the display monitor .

  6. Asus VivoBook X540SA-BPD0602V Battery Removal: paso 6, imagen 1 de 1
    • Observe where the ribbons connect to the motherboard, there are two connections. Each connection has a black clamp. To remove the ribbon, lift the black clamp up to disconnect it.

  7. Asus VivoBook X540SA-BPD0602V Battery Removal, Battery: paso 7, imagen 1 de 1
    • Very carefully, remove the batteries with the blue plastic iFixit opening tool. Focus removing the battery near the highlighted area.

    • The batteries should all be connected to one another and come out of the device as a single unit.

    • Be careful not to rip any of the black plastic covering the batteries. Exposed battery parts can lead to explosions. If the case is ripped, re-wrap them, or properly dispose of them. Do not reuse them.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Equipo

USF Tampa, Team S1-G111, Cagle Fall 2017 Miembro de USF Tampa, Team S1-G111, Cagle Fall 2017

USFT-CAGLE-F17S1G111

5 Miembros

14 Guías creadas

Un comentario

Easy, and nice guide.
To be honest you don't need make pint 6 - unplug keyboard and pad cable. You can just move cover a bit to your side (pull into your direction) then you will get a lot space to pull out battery.

Damian Gepard - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 21

Ultimos 30 días: 71

Todo El Tiempo: 9,306