Saltar al contenido principal

Introducción

Is your Asus TF300T Android Tablet not charging or powering up? If this this the case your battery may need to be replaced. This replacement guide is intended for those who are experiencing battery related problems with their Asus TF300T Android Tablet. After trouble shooting the various problems this guide is a last resort to correct the issue.

  1. Begin the process by making sure that the dock is disconnected and the power is turned off. Start by using the plastic opening tool on the side opposite the dock/ charging port. Begin to open the device along the short sides of the tablet. When you have reached the side with the charging/ dock port be gentle with the opening tool due to the thinner plastic that could be broken with excessive force.
    • Begin the process by making sure that the dock is disconnected and the power is turned off.

    • Start by using the plastic opening tool on the side opposite the dock/ charging port. Begin to open the device along the short sides of the tablet.

    • When you have reached the side with the charging/ dock port be gentle with the opening tool due to the thinner plastic that could be broken with excessive force.

    • Once the opening tools have completely made their way around the device use the spudger to separate the back panel from the screen and expose the inside.

  2. The Asus Transformer series tablets have a hard power switch. This should be turned off before working on the tablet.
    • The Asus Transformer series tablets have a hard power switch. This should be turned off before working on the tablet.

    • Locate the power switch near the power button on the top left. Use a tool to slide it to the position marked 'off'

    • For many repairs, like replacing the screen or digitizer, you do not need to remove the battery once you hve turned the tablet off. Be very careful not to short anything out with metal tools!

  3. Using the Phillips #00 screwdriver remove all of the screws connecting the battery to the mother board. Once the initial screws have been removed as indicated by the photo, use the spudger to remove the cover concealing the the clips for the dock sensor and a few more screws. Again remove the screws with the same screwdriver and use the spudger to disconnect the spudger sesors from their respective clips.
    • Using the Phillips #00 screwdriver remove all of the screws connecting the battery to the mother board.

    • Once the initial screws have been removed as indicated by the photo, use the spudger to remove the cover concealing the the clips for the dock sensor and a few more screws.

    • Again remove the screws with the same screwdriver and use the spudger to disconnect the spudger sesors from their respective clips.

    • Once the battery is freed use the spudger to remove the battery from its spot

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Jonathan Barros

Miembro Desde 22/10/14

1,233 Reputación

5 Guías creadas

Equipo

UMass Dartmouth, Team 2-6, Duarte Fall 2014 Miembro de UMass Dartmouth, Team 2-6, Duarte Fall 2014

UMASSD-DUARTE-F14S2G6

4 Miembros

10 Guías creadas

Un Comentario

Great instructions. The link to buy the battery is broken. I believe the part number is C21-TF201X. I found it on Amazon and Ebay.

Robert Cole - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 7

Ultimos 30 días: 34

Todo El Tiempo: 18,374