Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a metal spudger, pick out the stoppers located on the bottom left/right corners of the screen, revealing the screws underneath them.
-
Unscrew the two 4.25mm screws with the JIS 00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the metal spudger, pry off the edges of the screen's frame from the outside.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There should be four silver brackets holding the screen in place underneath. Unscrew the center 3.35mm screws in each bracket as shown with the JIS 00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the monitor face down. Slowly remove the adhesive tape on the back of the monitor, and remove the connector that the tape is holding.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.