Saltar al contenido principal

Introducción

This guide will help you replace the wireless card in case you are upgrading or component failure. Be sure to follow this guide in a well lit room on a flat surface. Acquire the necessary tools before hand and have a cup or a magnetic plate to keep track of all the screws.

Partes

No se especificaron partes.

  1. Remove the ten 10mm Phillips #0 screws on the back of the laptop.
    • Remove the ten 10mm Phillips #0 screws on the back of the laptop.

  2. Use the iFixit opening tool along the edge of the laptop to pry open the back.
    • Use the iFixit opening tool along the edge of the laptop to pry open the back.

  3. Remember the position of the wires. You will then pull off the two wires connected to the wireless card.
    • Remember the position of the wires. You will then pull off the two wires connected to the wireless card.

  4. Remove the screw holding down the wireless card.
    • Remove the screw holding down the wireless card.

    • After the screw disconnects the card "jumps up" a little.

  5. Pull the wireless card out of its socket.
    • Pull the wireless card out of its socket.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Houston Koontz

Miembro Desde 06/11/18

307 Reputación

2 Guías creadas

Equipo

IUPUI, Team S1-G2, Hovde Fall 2018 Miembro de IUPUI, Team S1-G2, Hovde Fall 2018

IUPUI-HOVDE-F18S1G2

3 Miembros

3 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 56