Saltar al contenido principal

Astak Mole Antenna Replacement

Qué necesitas

  1. Astak Mole Antenna Replacement, Lower Case: paso 1, imagen 1 de 1
    • Remove the four bottom tabs in order to access the bottom screws.

  2. Astak Mole Antenna Replacement: paso 2, imagen 1 de 1
    • Remove all four 14 mm Phillips #1 screws.

  3. Astak Mole Antenna Replacement: paso 3, imagen 1 de 1
    • Remove the SD card.

  4. Astak Mole Antenna Replacement: paso 4, imagen 1 de 1
    • Pry up the motherboard on the four points using a spudger.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

  5. Astak Mole Antenna Replacement: paso 5, imagen 1 de 1
    • Gently pull back the motherboard to expose many of the component's wired connections.

  6. Astak Mole Antenna Replacement, Antenna: paso 6, imagen 1 de 2 Astak Mole Antenna Replacement, Antenna: paso 6, imagen 2 de 2
    • Unscrew the antenna in a counter-clockwise rotation.

  7. Astak Mole Antenna Replacement: paso 7, imagen 1 de 1
    • Take out the screw holding the antenna wire with the PH1 size Phillips head bit.

    • Screw length: 5.3mm

  8. Astak Mole Antenna Replacement: paso 8, imagen 1 de 1
    • Gently pry open the circuit board attached to the antenna wire using a metal spudger.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

  9. Astak Mole Antenna Replacement: paso 9, imagen 1 de 1
    • Remove the antenna female end from the motherboard.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Equipo

USF Tampa, Team 2-2, Blackwell Fall 2016 Miembro de USF Tampa, Team 2-2, Blackwell Fall 2016

USFT-BLACKWELL-F16S2G2

4 Miembros

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 5

Todo El Tiempo: 439