Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Make sure the cord is unplugged.

  1. Remove the orange main housing unit from the vacuum bucket by pulling outward on the handle tabs while lifting upward as shown.
    • Remove the orange main housing unit from the vacuum bucket by pulling outward on the handle tabs while lifting upward as shown.

  2. Remove the five 15mm PH2 screws.
    • Remove the five 15mm PH2 screws.

  3. Remove the 15 mm T20 screw. This screw is located nearest the power cord.
    • Remove the 15 mm T20 screw. This screw is located nearest the power cord.

  4. Gently separate the upper and lower sections of the main housing. Gently separate the upper and lower sections of the main housing.
    • Gently separate the upper and lower sections of the main housing.

  5. SALTEA LA ACTUALIZACIÓN

    Ahorra reparando con un kit todo en uno.

    Compra Kits de Reparación

    SALTEA LA ACTUALIZACIÓN

    Ahorra reparando con un kit todo en uno.

    Compra Kits de Reparación
  6. Using a PH2 screw head, unscrew the two 15mm screws as shown.
    • Using a PH2 screw head, unscrew the two 15mm screws as shown.

  7. Pull the black handle. Using a PH2 screwdriver, unscrew the single 12mm screw shown. Using a PH2 screwdriver, unscrew the single 12mm screw shown.
    • Pull the black handle.

    • Using a PH2 screwdriver, unscrew the single 12mm screw shown.

  8. Use the blue opening tool to open up the black handle. Use the blue opening tool to open up the black handle.
    • Use the blue opening tool to open up the black handle.

  9. Using your fingers, gently take out the black cords. Careful to not break the black cords.
    • Using your fingers, gently take out the black cords.

    • Careful to not break the black cords.

  10. Using the spudger, take out the switch. Do this by pushing the spudger against the switch on both sides as shown and then pull the switch out. Using the spudger, take out the switch. Do this by pushing the spudger against the switch on both sides as shown and then pull the switch out.
    • Using the spudger, take out the switch. Do this by pushing the spudger against the switch on both sides as shown and then pull the switch out.

  11. Replace the switch shown.
    • Replace the switch shown.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Renzo La Rosa

Miembro Desde 09/02/16

212 Reputación

1 Guía escrita

Equipo

IUPUI, Team 2-1, Baechle Spring 2016 Miembro de IUPUI, Team 2-1, Baechle Spring 2016

IUPUI-BAECHLE-S16S2G1

4 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 12

Ultimos 30 días: 44

Todo El Tiempo: 1,002