Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Apple TV 1st Generation Lower Case Replacement

Qué necesitas

  1. Apple TV 1st Generation Lower Case Replacement, Lower Case: paso 1, imagen 1 de 1
    • Flip the Apple TV over so that the bottom of the unit is facing up.

    • You need to remove the rubber base to get access to the screws.

    • Starting at one side of the device, use a hairdryer or a heat gun to soften the adhesive holding the rubber base in place.

    • The rubber base will be hot after heating, take extreme caution while proceeding to avoid personal injury.

    • While the adhesive is still warm, peel the bottom of the rubber base upwards to detach it from the metal plate.

    • Repeat the procedure described above until the rubber base has been completely removed.

  2. Apple TV 1st Generation Lower Case Replacement: paso 2, imagen 1 de 1
    • Remove the four T10 Torx screws that secure the lower case to the upper case.

  3. Apple TV 1st Generation Lower Case Replacement: paso 3, imagen 1 de 1
    • Carefully lift the lower case from the upper case enough to allow access to the internals of the Apple TV.

    • Be aware that the hard drive is physically attached to the lower case and that a ribbon cable runs from the drive to the logic board in the upper case.

  4. Apple TV 1st Generation Lower Case Replacement: paso 4, imagen 1 de 2 Apple TV 1st Generation Lower Case Replacement: paso 4, imagen 2 de 2
    • Carefully pull the hard drive data cable straight up from its socket on the logic board.

    • During reassembly, make sure the hard drive data cable is firmly seated in its socket on the logic board; otherwise, during boot-up you will see a flashing question mark "?".

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

CCarvalho

Miembro Desde 11/08/09

283 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 18-5, Maness Fall 2009 Miembro de Cal Poly, Team 18-5, Maness Fall 2009

CPSU-MANESS-F09S18G5

5 Miembros

6 Guías creadas

Un comentario

This guide may make more sense as a teardown, since its not really showing any repairs or replacements.

Alex Jansen - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 5

Todo El Tiempo: 8,389