Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lay the display facing down with the stand away from you.
-
Remove the three size 2.0 hex screws on the swing arm and remove the swing arm as well as the plastic shield under it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the size 2.5 hex screws from each corner that connects the panels to the display and remove them.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Rotate the display so the legs of the display are now facing you
-
Grip the top of the clear panel and lift it upwards, and pull the ADC cable through the hole.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the grey back panel by lifting the bottom and pulling the ADC cable through the hole.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The next layer will be a shiny metal panel, which might have some stickers. Make sure to remove these stickers.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Now locate and remove the lone Phillips screw holding the EMI shield to the display
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Now that the screw has been removed, slide the panel towards your body and lift it out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four screws holding the logic board to the display
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove these seven cables connected to the logic board.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.