Saltar al contenido principal

Apple Studio Display M2454 Main Computer Cable Replacement

Qué necesitas

  1. Apple Studio Display M2454 Main Computer Cable Replacement, Main Computer Cable: paso 1, imagen 1 de 1
    • First, the back panel needs to be removed to access the cable connectors.

    • Locate the three 2mm hex screws located on the top of the stand and remove them.

    • Now locate and remove the four 2mm hex screws on the corners of the back panel.

    • Now remove the back panels while pulling the cable through them without damaging either part.

  2. Apple Studio Display M2454 Main Computer Cable Replacement: paso 2, imagen 1 de 1
    • Remove the metal back plate by using the #2 philips head screwdriver and removing the top screw.

    • Now remove the two other philips screws located below the cable with the philips head screwdriver.

    • With all the screws removed, push the metal plate towards the bottom of the monitor to release the clips holding it to the monitor.

    • Pull the metal plate away.

  3. Apple Studio Display M2454 Main Computer Cable Replacement: paso 3, imagen 1 de 1
    • Locate and remove the four #2 phillips screws located on the corners of the stand bracket, using the phillips head screwdriver.

    • Pull bracket away from monitor.

  4. Apple Studio Display M2454 Main Computer Cable Replacement: paso 4, imagen 1 de 1
    • Remove the cable hold-down with #2 phillips head screwdriver.

  5. Apple Studio Display M2454 Main Computer Cable Replacement: paso 5, imagen 1 de 1
    • Remove the screw at the bottom of the plastic bracket, using #2 phillips head screwdriver.

    • Pull the plastic bracket free.

    • Note the plastic pegs lining the bracket up with the monitor.

  6. Apple Studio Display M2454 Main Computer Cable Replacement: paso 6, imagen 1 de 1
    • Remove tape holding down the white connector to the LCD main board.

  7. Apple Studio Display M2454 Main Computer Cable Replacement: paso 7, imagen 1 de 1
    • With tape removed, the connections on the LCD main board can be disconnected.

    • First, remove the single hold-down using the philips head screwdriver.

    • Now locate the three connections the main cable makes with the monitor. Two are on the LCD Main Board and one other to the side.

    • Disconnect the white connector to the LCD main board by gently lifting tab with small pry tool and pulling out.

    • The tabs can easily break off, be extra careful

    • Disconnect the black connector to the LCD main board by pressing the tab and pulling out.

  8. Apple Studio Display M2454 Main Computer Cable Replacement: paso 8, imagen 1 de 1
    • Now remove the connection not on the LCD Main Board by pulling back the tape holding the wires down first.

    • Remove the connector by hand.

  9. Apple Studio Display M2454 Main Computer Cable Replacement: paso 9, imagen 1 de 1
    • Finally, the main cable can be replaced by pulling the old cable away and repeating the previous steps in reverse with a new, working main cable.

Linea de Meta

Una persona más ha completado esta guía.

Dylan Perry

Miembro Desde 01/20/10

177 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 13-27, Maness Winter 2010 Miembro de Cal Poly, Team 13-27, Maness Winter 2010

CPSU-MANESS-W10S13G27

4 Miembros

9 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 4

Ultimos 30 días: 14

Todo El Tiempo: 5,596