Introducción

This repair will need:

A T8 Torx screwdriver.

Partes

No se requieren partes.

After completing the initial disassembly, you may proceed to hard drive replacement.
  • After completing the initial disassembly, you may proceed to hard drive replacement.

After completing the initial disassembly, you may proceed to hard drive replacement.

Aubrey - Contestar

First, you will need to remove the five T8 torx screws that mount the hard drive to the internal frame.
  • First, you will need to remove the five T8 torx screws that mount the hard drive to the internal frame.

  • Next, you will remove the mounting frame and the plastic shield.

First, you will need to remove the five T8 torx screws that mount the hard drive to the internal frame.

Aubrey - Contestar

Next, you will remove the mounting frame and the plastic shield.

Aubrey - Contestar

  • You can use a spudger (tool shown in photo) to remove the ribbon cable from the hard drive.

You can use a spudger (tool shown in photo) to remove the ribbon cable from the hard drive.

Aubrey - Contestar

  • Carefully, pry the ribbon away from the pins.

Carefully, pry the ribbon away from the pins.

Aubrey - Contestar

  • Attach the ribbon cable to the new hard drive and follow steps 1-3, in reverse, to complete the installation.

Attach the ribbon cable to the new hard drive and follow steps 1-3, in reverse, to complete the installation.

Aubrey - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Tyler

Miembro Desde 10/04/11

129 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 20-66, Walters Spring 2011 Miembro de Cal Poly, Team 20-66, Walters Spring 2011

CPSU-WALTERS-S11S20G66

4 Miembros

3 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 3

Últimos 30 Días: 20

Todo El Tiempo: 3,667