Introducción

This repair will need:

A T8 Torx Screwdriver.

Partes

No se requieren partes.

  1. With the Generally Disassembly completed, you may proceed to floppy drive installation.
    • With the Generally Disassembly completed, you may proceed to floppy drive installation.

    Agregar Comentario

  2. Remove the plastic panel at the bottom of the display.
    • Remove the plastic panel at the bottom of the display.

    Agregar Comentario

    • Reverse the computer to access the peripheral panel in the back.

    • Remove the two T8 Torx screws on either side of the bar code panel.

    Agregar Comentario

    • Reverse the computer to have the monitor and mousepad facing you.

    • Remove the plastic panel underneath the display.

    Agregar Comentario

    • Remove the three T8 Torx screws securing the floppy drive to the frame.

    Agregar Comentario

    • Using a spudger, lift the plastic tabs on the floppy drive securing the ribbon cable to the ribbon port.

    Agregar Comentario

    • Lift the defective floppy drive from the body of the computer.

    Agregar Comentario

    • Replace the defective drive with a new drive.

    • Follow these instructions in reverse order to reassemble the device.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Kevin Peters

Miembro Desde 19/04/11

114 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 20-66, Walters Spring 2011 Miembro de Cal Poly, Team 20-66, Walters Spring 2011

CPSU-WALTERS-S11S20G66

4 Miembros

3 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 2

Últimos 30 Días: 11

Todo El Tiempo: 2,076