Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.
Introducción
This guide shows the reader how to disassemble the Apple Cinema Display M8149 so that the screen can be replaced. The tools required for this section are the spudger and the PH 2 screwdriver.
Qué necesitas
-
-
Place the Cinema Display so that it is lying on its face and the feet are pointed away from you.
-
Remove the three screws (9.52 x 4.43mm) that connect the back foot to the hinge using the Hex Key.
-
Remove the back foot from the hinge mount by grabbing the foot and pulling upwards.
-
-
-
-
Carefully remove the two tape plugs on either side of the control board using a spudger.
-
-
-
Turn your attention to the left side of the cinema display.
-
Using your fingers, unplug the small white plugs with pink wires from the top and bottom of the circuit board.
-
Using the PH 2 screw driver, remove the four screws (6.9 x 2.55 mm) holding down the circuit board.
-
Remove the circuit board by gently lifting it from the display.
-
-
-
Lift the screen from the surrounding front cover by sliding your fingers between the two pieces and lifting.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
3 personas más completaron esta guía.