Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
First start by peeling off the outer rubbery covering on the bottom of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After removing the rubber covering, unscrew the five 4.9mm Phillips screws in the holes of the plastic casing.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After unscrewing all five screws, remove the plastic casing. The back should now look like the picture shown.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The inner metal casing is latched inside the outer white plastic shell, so insert a pry tool underneath the metal casing and pry it apart from the shell.
-
It should make a click when it comes apart.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the outer casing.
-
The exposed logic board should look like this.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.