Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.
  • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

Agregar Comentario

Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.
  • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

Agregar Comentario

  • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

Agregar Comentario

  • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

Agregar Comentario

  • Remove the four 4.3mm phillips screws from the bottom of the metal casing.

Agregar Comentario

  • Lift and separate the top and bottom of the metal casing. You will now expose the motherboard and the AirPort card.

  • To remove the AirPort card, gently pull the plastic tab horizontally.

Agregar Comentario

  • Locate and remove the three 5.0mm phillips screws from the heat sink.

  • Lift to remove the heat sink from the motherboard.

Agregar Comentario

  • Locate and remove the five 7.5mm phillips screws from the motherboard.

  • Lift and separate the motherboard from the bottom metal casing.

  • There will be a loose hexagonal female screw extender under the motherboard.

Agregar Comentario

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Michael Garcia

Miembro Desde 12/10/11

369 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 17-15, Regan Fall 2011 Miembro de Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 6

Todo El Tiempo: 2,715