Repara tus cosas Comunidad Tienda

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Apple AirPort Extreme Model A1034 Internet Card Replacement

Qué necesitas

  1. Apple AirPort Extreme Model A1034 Internet Card Replacement, Outer Case: paso 1, imagen 1 de 1

    • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

    Traducir

  2. Apple AirPort Extreme Model A1034 Internet Card Replacement: paso 2, imagen 1 de 1

    • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

    Traducir

  4. Apple AirPort Extreme Model A1034 Internet Card Replacement: paso 3, imagen 1 de 2 Apple AirPort Extreme Model A1034 Internet Card Replacement: paso 3, imagen 2 de 2

    • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

    Traducir

  5. Apple AirPort Extreme Model A1034 Internet Card Replacement: paso 4, imagen 1 de 1

    • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

    Traducir

  6. Apple AirPort Extreme Model A1034 Internet Card Replacement, Internet Card: paso 5, imagen 1 de 1

    • Remove four 1mm phillips screws from the bottom.

    Traducir

  7. Apple AirPort Extreme Model A1034 Internet Card Replacement: paso 6, imagen 1 de 1

    • Separate the top and bottom of the metal casing. You will now expose the motherboard and AirPort card.

    • To remove the AirPort card, gently pull the plastic tab horizontally.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Autor

con 5 otros colaboradores

Michael Garcia

Miembro Desde 10/12/11

411 Reputación

5 Guías creadas

Insignias: 11

+ 8 más insignias

Equipo

Cal Poly, Team 17-15, Regan Fall 2011 Miembro de Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Miembros

13 Guías creadas

Un comentario

Thank you so much for your guide! I was challenging myself to do it without cheating, but couldn't figure out how to release the bottom plastic layer from the main unit inside after I undid the 3 Torx screws. Thankfully you avoided me having to break the whole unit by showing where the central screw hidden beneath the S/N 3 barcode sticker was and that it was Philips not Torx, and I can now pinch the A1027 wifi card and use it in my G5, instead of relying on ageing ethernet! Bless you kind folks!

HumptyDumpty - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 4

Todo El Tiempo: 5,136