Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the black connector on the top of the metal casing by gently pulling horizontally.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 4mm phillips screws to remove antenna.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The circuit board connected to the antenna is attached to the metal case with foam adhesive.
-
Gently peel or cut the foam holding the circuit board with a knife and remove it from the AirPort.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.