Apex Tablet 7 Back Panel Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

This guide will show you how to open the back panel. This will allow the user to gain access to the device components and is necessary for most replacements and repairs for the Apex Tablet 7.

Qué necesitas

Paso 1 Back Panel

Apex Tablet 7 Back Panel Replacement, Back Panel: paso 1, imagen 1 de 1

Unscrew the two 2.70 mm Phillips #00 screws on the side of the tablet that has the buttons and the headphone jack (bottom side when holding upright).

Traducir

Paso 2

CAUTION: When removing the back panel of the tablet, take caution around the speaker. This is located in the lower right corner when looking at the back of the tablet. There are two wires inside connecting the tablet back panel to the device itself and this connection may be severed if the back is pulled off without care.
This connection is shown in red on the pictures.

Traducir

Paso 3

Slide a plastic opening tool in between the edge of the back panel and the the top edge of the device.
Run the plastic opening tool along the sides of the tablet while keeping it in the crack between the tablet and the back panel to create an opening.

Traducir

Paso 4

Apply pressure using your hand to pop the back panel off slowly, taking extra care around the speaker connection.

Traducir

Paso 5

The back panel should now be disconnected from the device. This provides access to the components of the device for repairing and replacing parts of the tablet.

Traducir