Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
first remove the 2 screws at the green plastic plate.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
remove the plastic plate ( battery compartment)
-
you'll see that there are 2 more screws. Remove them.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
now gently remove the green plastic plate arrounf the baby monitor ( arround the screen) use a spudger to click it open.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
now open the monitor by clicking it open or slide it open. Sometimes its easier to use a spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
2 battery's were exploded so the acid was on the black electric power wire.
-
use a cotton swab with a little bit of destilled water.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
remove the 2 PCB's by removing the screws shown in the picture.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
pull the first PCB up and remove the screws of the second PCB.
-
after removing the two PCB's, clean the acid on the PCB.
-
after cleaning the PCB's put it al together again.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
first remove the battery lid. 1 screw.
-
slide it out like you see in picture
-
remove battery's
-
Cancelar: No complete esta guía.
6 personas más completaron esta guía.
13 comentarios
Hi. At my Angelcare (AC401) parent unit the screen has slowly become worse and worse. At first, parts of the temperature figures dissapeared, then the symbols around and now I no longer see anything... But the unit still works! (And alert me if the baby's crying) What do you think, is there anything I can do or do I need to buy a new one?
Hi There. I’m having the same problem. Did you find a fix or did you buy a new unit?
Eugene -