Introducción

Follow this replacement guide if you are experiencing issues with the user interface of this device (e.g. buttons are not working, LEDs are dead, no voice recognition).

Partes

No se requieren partes.

  1. Remove the rubber layer beneath the device.
    • Remove the rubber layer beneath the device.

    • Look for the crater beneath the rubber layer and place your thumb on it. Hold down and lift off the cover with your other hand.

    • Remove the four 8.0 mm T8 Torx screws on the lid.

    • Remove the lid from the device.

    Agregar Comentario

  2. Use a spudger to flip up the small flap on the ZIF connector.
    • Use a spudger to flip up the small flap on the ZIF connector.

    • Gently pull the ribbon cable out of the ZIF connector.

    • Lift the AMP Board gently while sliding the ribbon cable out through the center hole to reveal another set of wires underneath the board.

    Agregar Comentario

    • Use a spudger to lift up one of the small flaps on only one side of the female connector.

    • Pull on the wire toward the lifted side until the male connector is disconnected.

    • Remove the AMP Board.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove the four 30.0 mm T8 Torx screws in the corners.

    • Remove the large plastic piece on top of the subwoofer while threading the ribbon cable and male connector through the hole.

    Agregar Comentario

    • Remove the lid on top of the subwoofer.

    • Flip the device over and let the subwoofer fall into your hand.

    • The subwoofer is a strong magnet. Keep it away from any other electronics and unshielded wires.

    Agregar Comentario

    • Remove the four 16.0 mm T8 Torx screws underneath the speaker.

    • Once you unscrew the four 16.0 mm T8 Torx screws, the remaining components of the device have no support. Take caution when flipping the device over to avoid damage to the remaining components.

    • Flip the device over while supporting the front panel side.

    • Remove the front panel cover by lifting it.

    Agregar Comentario

    • Lift the MIC board over and lay it down against a surface.

    • Use a spudger to flip up the small flap on the ZIF connector.

    • Disconnect the ribbon cable from the MIC board and pull the board away.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Billy Pho

Miembro Desde 08/10/18

308 Reputación

2 Guías creadas

Equipo

Cal Poly, Team S4-G4, White Fall 2018 Miembro de Cal Poly, Team S4-G4, White Fall 2018

CPSU-WHITE-F18S4G4

3 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 2

Últimos 7 Días: 12

Últimos 30 Días: 20

Todo El Tiempo: 70