Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a metal spudger, gently pry the cover off the bottom of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To detach the small clips from the connectors, place the flat end of the plastic spudger underneath the clip and gently lever it away from the center of the device.
-
To detach the large clip from its connector, place the flat end of the spudger on the clip and lever it upward out of the connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using two fingers, pinch the power supply wire and gently lift it upward. Move it away from the metal plate.
-
Next, unscrew the four 3.3mm T8 Torx screws and remove the metal plate.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the T8 Torx screwdriver head and replace it with the 60 mm extension; then, add the T9 Torx head.
-
Loosen, but do not remove the two screws at the bottom of the 1.2-inch wide gap in the middle of the internal structure.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using only your fingers, gently compress the internal structure and pull evenly upward to remove it from the white case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Rotate the internal structure so that the side containing the 5 white ports is facing upward.
-
Unscrew the four 10.25mm T8 screws holding the heat sink.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Wedge the corner of the plastic spudger under one of the silver antenna clips. Gently lever the tip of the spudger away from the logic board to detach the antenna clip.
-
Repeat this for all six clips.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the internal structure upside down so that the metallic plate (antenna array) is facing upward.
-
Unscrew the two 2.8 mm T6 Torx screws and remove the antenna array.
-
Cancelar: No complete esta guía.
5 personas más completaron esta guía.